D&R AIRLAB Manual de usuario descargar pdf (Pagina 8)

Triple Line Input Stereo Module

Airlab from D&R Phone +31 294 418014, email: [email protected] Page 8

4 TRIPLE LINE INPUT STEREO MODULE

MONO

Every channel has a mono switch with LED to send a mono input signal to both outputs of

the module.

(PHANTOM POWER, not on front panel.

48 volt switchable by a jumper setting (see also chapter 12))

MIC-TRIM

The trim control adds an extra 13dB of mic gain to the mic pre-amp. An optimal gain range

can be accomplished in this way.

GAIN

The gain control adjusts the incoming signal level on the MIC and LINE input.

LINE A

The triple module default is in 'LINE A' mode. Operating the 'LINE B' switch or the MIC

switch changes the mode.

LINE B

When line B is selected (with optional RIAA correction amp), the green LED is illuminated.

MIC

MIC input selector switch between MIC-input or Line-A/B input. When the LED is illuminated

the MIC-input is activated.

HIGH

Adjusts high frequencies with +/- 12 dB at 10 kHz shelve.

MID

Adjusts mid frequencies with +/- 12 dB at 1 kHz bell.

LOW

Adjusts the low frequencies with +/- 12 dB at 60 Hz bell.

SUB

The sub switch assigns the signal in stereo to the sub output.

PROG(RAM)

The program switch assigns the signal in stereo to the program output.

STEREO AUX

Transmits a stereo signal to the AUX master post fader. A jumper on the board determines

whether this is pre or post VCA.

The channel 'ON' switch also affects the aux send (only when set to post fader).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 75 76

Sin comentarios

D&R AIRLAB Manual de usuario Pagina 8